The GPS on the software though is showing correct.

I normally set mine up with the computer and run it then on battery (stand alone) I normally just watch WSPR-Rocks (http://wspr.rocks) Here is a sample of the table shown for G4FKI and then mine. mine shows tx grid in 6 digit mode.

Thats what i tried but it still gave a 4 digit position saving of course before closing and reopening. When i put my callsign in again i was getting the full 6 digits on my location. What crossed my mind was if the original position was set at 4 digits, originally mine was, in wsprnet.org (my account) then he would never get the full 6 digits reported by wsprnet. I can't remember how i altered mine whether i edited it or went to https://www.rfzero.net/documentation/tools/wsprnet-locator-update/?fbclid=IwAR2HPnWQ52rOaKmK2LnCryX26H9NBsiu2bdQNptQf5aC5zjlX4U9D_lTIRg its been so long ago since i sold my wsprlite and then bought the Zachtek.

Yep, might be that when he registered he only input 4 digits so have sent him details how to edit or reregister, not sure whether thats the answer or not until i speak to him later.

Ok thanks for the email from a member, hadn't seen the satellite option at the bottom and WSPR Rocks version, looks better now (http://wspr.rocks) option to add callsigns are good. As below map looks in my opinion better.

To follow on, i can of course change the signal colour to the same as WSPR.net while its better i would prefer to change the map if it were possible as there are only 2 options to change signal colour, original and wsprnet. This is what the other option looks like.

Thanks Harry, yes that makes sense. The SGC covers 6m and i want to try it on there, will tune it up on 6m with my main transceiver and see how if there is any wspr activity at my location.

Thats Great it answers my question too Harry, I wasn't sure as in the manual it doesn't say "reported power" it just say's output power, maybe i should look at the actual software rather than read the manual 😀

I have dropped Harry an email about output power, im used to using the wsprlite which ive now sold if favour of the Zachtek desktops, mainly because they have built in filters, yes i could have bought a filter kit but I have glaucoma now so soldering is no longer something i could do. What i was wondering is the drop down output power or custom just for reporting what output power OR can you actually alter the output power of the unit. I can't see any reference to that in the manual. IF it does alter the power output what setting is max and what is minimum in dBm in relation to mw? Love the units though, nice to not have to watch the clock to push the button!