4-way Active signal splitter

This board will let you share one antenna between four WSPR Receivers.
It can also be used to distribute 10MHz reference clocks or any other signal in the 100kHz to 100MHz range.
If you need more than four output several boards can be connected together to give you any number of outputs.
The board contains high dynamic range amplifiers that will pass the signal to all ports without being reduced in amplitude and with minimum distorsion.
The intermodulation is very low from 100kHz to 30MHz but the board can be used for signals up to 100MHz with some reduction in IP3 above 30MHz
 
This is a partial kit.
All SMD components are pre-solered only the SMA connectors needs to be soldered on and that can be done with a regular soldering iron.
 
DC in can be anything from 12 to 25V and uses a barrel plug (inluded)
Current draw is less than 150mA.
 
Does not include any cables, I recomend getting a few of my 10cm long SMA to SMA cables.
(Product number 1059)
 
More information on the documentation page